Anaheim, CA 92805 • Incorporated City • Orange County • Family-Owned Since 1970 • CSLB #265709
Steel / Metal Stud Framing in Anaheim, CA
Light-gauge steel and metal stud framing in Anaheim — interior partitions, tenant-improvement walls, soffits, and fire-rated assemblies. We frame the wall so the drywall stays flat: Harbor Boulevard shops, Katella Avenue build-outs, Anaheim Hills interiors, and house remodels in 92801 through 92808.
Anaheim Framing From the Fairfield Shop
Ron Hogan Drywall has been family-owned since 1970. We are based in Fairfield — an Orange County run, not a Harbor Boulevard storefront. Anaheim is an incorporated city in Orange County. It is not a neighborhood of Buena Park, Garden Grove, or Fullerton. It is not Los Angeles County. The City of Anaheim incorporated on February 10, 1876. Anaheim Hills is part of the city, not its own city. Orange, Stanton, and Santa Ana are different cities. The street ZIPs are 92801, 92802, 92804, 92805, 92806, 92807, and 92808. This page is steel / metal stud framing at City of Anaheim addresses — Harbor Boulevard, Katella Avenue, Ball Road, Lincoln Avenue, and Anaheim Boulevard. The street decides the bid.
Text “Anaheim” with the plans or a photo of the room. If the scope is interior metal studs — or frame-and-hang on the same trip — we schedule it.
Metal Stud Work We Do in Anaheim
Interior partition walls
Track, studs, and bracing for new rooms, office layouts, and non-load-bearing walls at City of Anaheim addresses. This is the skeleton the board hangs on.
Harbor Boulevard and Katella TIs
Shop, restaurant, hotel, office, medical, and commercial build-outs on Harbor Boulevard and Katella Avenue when the drawing says steel studs. If the plan names metal, that is the bid. Commercial framing →
Resort, Platinum Triangle, and Ball Road interiors
Occupied shops and commercial walls on Ball Road, Lincoln Avenue, Anaheim Boulevard, and the resort side of Harbor. Occupied buildings change the layout — not the stud spec. The resort district is still the City of Anaheim.
House remodel partitions
New interior steel walls inside an existing Anaheim house — west Anaheim, east Anaheim, or Anaheim Hills — when the finish needs a straighter plane than bowed lumber. Wood structure stays wood unless the plan says otherwise. Metal vs wood →
Soffits, bulkheads, and chases
Dropped ceilings, kitchen hood wraps, and framed openings so boxes, ducts, and lights have a home before drywall.
Fire-rated and heavier-gauge walls
Listed assemblies, Type X board later, and heavier studs when the plan or the engineer calls for them. The rating is the whole wall — not the stud alone.
Frame and hang together
One crew frames the metal, hangs the board, and can finish it. Split bids leave missing backing and wavy walls. Services →
Which Stud Belongs on an Anaheim Job
| Stud | Use it when | Skip it when |
|---|---|---|
| Light-gauge metal (what we frame) | Harbor Boulevard TI, Katella shop, rated walls, or a finish that needs a flat plane for Level 4 / Level 5 | You need beams, columns, or structure that hold the building up — that is a different contractor |
| 25-ga interior studs | Short, non-load-bearing partitions with a normal finish | Tall walls, high-abuse corridors, or a spec that names 20-ga or heavier |
| 20-ga / heavier track and studs | Taller commercial walls, shop TIs, or engineer notes | A simple closet that never needed the extra gauge |
| Wood studs | Most Anaheim house walls with no commercial spec | The plan already says steel, or the finish will show every bow |
| Furring / hat channel on masonry | Concrete or masonry walls that need a cavity for boxes before drywall | Glue-only board on a finished living space |
Compare studs: Metal vs wood → · Cost: Is steel expensive? → · Why it stays flat: Steel benefits →
Anaheim Streets, ZIP, and Permits
Anaheim is an incorporated city in Orange County — not a neighborhood of Buena Park and not Los Angeles County. There is a City of Anaheim Building Division. Orange County Building and Safety does not issue permits inside city limits. Street ZIPs are 92801, 92802, 92804, 92805, 92806, 92807, and 92808. Anaheim Hills uses 92807 and 92808 and is still the City of Anaheim. Some border ZIPs also touch Fullerton or Orange — the street, not the ZIP alone, decides the city. Area codes are 714 and 657. Text the street so the bid matches City of Anaheim Building Division at 200 S. Anaheim Boulevard — not the City of Garden Grove, not the City of Orange, and not Orange County Building and Safety.
Permits for City of Anaheim addresses run through City of Anaheim Building Division, Planning & Building: 200 S. Anaheim Boulevard, Suite 145, Anaheim, CA 92805. Call (714) 765-5153. Email: BuildingDivision@anaheim.net. Website is anaheim.net. Online permitting is Anaheim Next. Fire review, when required, is Anaheim Fire & Rescue — that is not the building permit office, and it is not Orange County Fire Authority. City of Buena Park, City of Fullerton, City of Orange, City of Garden Grove, City of Stanton, City of Santa Ana, and City of Cypress are different offices.
Buena Park sits north. Fullerton sits northeast. Placentia sits east. Orange sits east and southeast. Santa Ana sits south. Garden Grove sits southwest. Stanton sits west. Cypress sits northwest. Harbor Boulevard, Katella Avenue, Ball Road, Lincoln Avenue, Euclid Street, Brookhurst Street, Beach Boulevard, and State College Boulevard fill in the grid. Text the street so the bid matches City of Anaheim for a city address — not a Garden Grove or Orange permit that only shares a border.
Commercial work sits on Harbor Boulevard, Katella Avenue, Ball Road, and Anaheim Boulevard — shops, restaurants, hotels, medical suites, and office TIs, including the resort side of the city. Occupied houses and open shops change the layout — not the stud spec. The 5, the 91, and Harbor traffic change the schedule.
The usual mismatch is treating a Harbor Boulevard shop wall like a bedroom 2×4 — or hanging a Level 5 commercial finish on house framing that only needed wood hang-only. Interior metal studs do not hold the building up. Occupied houses need a clean layout, backing for cabinets and TVs, and a stud plane the finish can live with. Matching the spec still beats guessing the gauge. Send the plan sheet or a wide shot of the room. That photo decides wood hang-only vs new metal studs faster than a ZIP code.
How an Anaheim Metal-Stud Job Runs
1. Photos + place
Text (925) 791-9099 Anaheim, the street, and the plans or a photo of the wall.
2. Name the wall
Partition, TI layout, soffit, rated assembly, house remodel, or frame-and-hang. We will say if the existing framing can take the finish.
3. We frame it
Protect the space. Track, studs, backing, hang if scoped. Ready for inspection and board. 12-month warranty on our work.
Anaheim, CA
This page is steel and metal stud framing in the City of Anaheim — incorporated Orange County lots in 92801, 92802, 92804, 92805, 92806, 92807, and 92808, including Anaheim Hills — from our Fairfield shop. City of Anaheim Building Division is at 200 S. Anaheim Boulevard. Need the board hung and finished on the same job? Services → · Commercial framing: Commercial → · Contact: Contact →
Office: 2380 Palmer Circle, Fairfield, CA · CSLB #265709 · Check the number on cslb.ca.gov.
Not on This Page
No Orange County Building and Safety permit for an incorporated Anaheim address. No claim that Anaheim Hills is its own city. No claim that every 92806 address is Anaheim — Fullerton and Orange share that border. No storefront on Harbor Boulevard. No structural steel building. No promise that metal studs hold a house up. We frame interior light-gauge walls and hang drywall on wood or steel. A closet does not need a shaft-wall spec. Buena Park, Fullerton, Orange, Garden Grove, Stanton, Santa Ana, Cypress, and other addresses that only sit next to Anaheim are different places. This page is the City of Anaheim, CA — text the street so the permit office matches the address.
Anaheim Metal Stud FAQs
Do you do steel / metal stud framing in Anaheim?
Yes. Interior light-gauge metal stud framing in Anaheim, CA from our Fairfield shop — partitions, Harbor Boulevard and Katella TIs, resort and Ball Road interiors, Anaheim Hills house walls, soffits, heavier-gauge spec walls, and frame-and-hang.
Is Anaheim a city?
Yes. Anaheim is an incorporated city in Orange County. The City of Anaheim incorporated on February 10, 1876. It is not a neighborhood of Buena Park, Garden Grove, or Fullerton. There is a City of Anaheim Building Division. Permits run through that office, not Orange County Building and Safety.
Is Anaheim Hills the same as Anaheim?
Yes. Anaheim Hills is part of the City of Anaheim, mainly ZIPs 92807 and 92808. It is not its own city and not Yorba Linda. A Hills address still uses City of Anaheim Building Division. Text the street.
Is Garden Grove or Orange the same as Anaheim?
No. Garden Grove sits southwest. Orange sits east. Buena Park sits north. Fullerton sits northeast. Santa Ana sits south. Stanton sits west. Each is a separate incorporated city with its own building division. This page is the City of Anaheim. Text the street.
Is this structural steel?
No. We frame interior light-gauge studs, track, headers, and soffits. Beams, columns, and structure that hold the building up are a different contractor.
Do Anaheim houses use metal studs or wood?
Most house walls here are still wood. Metal wins on Harbor Boulevard and Katella TIs, rated walls, and remodels that need a straighter plane for a smooth finish. If the drawing names the stud, that wins.
Can you frame a shop on Harbor Boulevard or Katella Avenue?
Yes, when the address is inside the City of Anaheim. Occupied retail, restaurant, hotel, office, medical, and commercial tenant improvements on Harbor Boulevard, Katella Avenue, and Ball Road are a usual request — new partitions, soffits, and backing, then hang if the scope includes board.
Do you work occupied Anaheim buildings?
Yes. Floors are protected and the layout is planned around an occupied house or an open shop. The 5, the 91, and Harbor traffic change the schedule — not the stud spec.
What ZIP does this Anaheim page cover?
This page covers City of Anaheim street addresses in 92801, 92802, 92804, 92805, 92806, 92807, and 92808, including Anaheim Hills. Some border ZIPs also touch other cities, so text the street with the photos so the bid matches City of Anaheim Building Division.
Do you work Harbor Boulevard, Katella Avenue, and Ball Road?
Yes, when the address is inside the city. Harbor Boulevard, Katella Avenue, Ball Road, Lincoln Avenue, Euclid Street, Brookhurst Street, Anaheim Boulevard, and other City of Anaheim addresses are on this framing page. Text the street with the photos.
Who issues the permit in Anaheim?
City of Anaheim Building Division. 200 S. Anaheim Boulevard, Suite 145, Anaheim, CA 92805. Call (714) 765-5153. City of Garden Grove, City of Orange, and Orange County Building and Safety are different offices.
How much does metal stud framing cost in Anaheim?
It follows the gauge, wall height, how cut-up the layout is, fire rating, access, and whether we only frame or also hang and finish. Photos or plans first. Written scope — no hidden fees.
Are you licensed in California?
Yes. CSLB #265709. Look it up before you book us or anyone else. Work at a City of Anaheim address uses City of Anaheim Building Division — not Orange County Building and Safety unless the lot is outside city limits.
Need Anaheim Walls Framed Straight — Then Hung?
Call the family-owned crew that has been framing interiors and hanging board since 1970.
Call / Text (925) 791-9099