San Anselmo, CA 94960 • Incorporated 1907 • Marin County • Family-Owned Since 1970 • CSLB #265709
Steel / Metal Stud Framing in San Anselmo, CA
Light-gauge steel and metal stud framing in San Anselmo — interior partitions, tenant-improvement walls, soffits, and fire-rated assemblies. We frame the wall so the drywall stays flat: San Anselmo Avenue shops, Sir Francis Drake and Red Hill interiors, and house remodels in 94960.
San Anselmo Framing From the Fairfield Shop
Ron Hogan Drywall has been family-owned since 1970. We are based in Fairfield — a Ross Valley run, not a San Anselmo Avenue storefront. San Anselmo is an incorporated town in Marin County — not Fairfax, not San Rafael, and not Ross. It has its own Building Department at 525 San Anselmo Avenue, Second Floor. Street ZIP 94960 is San Anselmo. 94979 is a San Anselmo PO Box. 94930 is Fairfax. This page is steel / metal stud framing at Town of San Anselmo 94960 addresses — San Anselmo Avenue, Sir Francis Drake Boulevard, and Red Hill Avenue. The street decides the bid.
Text “San Anselmo” with the plans or a photo of the room. If the scope is interior metal studs — or frame-and-hang on the same trip — we schedule it.
Metal Stud Work We Do in San Anselmo
Interior partition walls
Track, studs, and bracing for new rooms, office layouts, and non-load-bearing walls in San Anselmo 94960 addresses. This is the skeleton the board hangs on.
San Anselmo Avenue TIs
Restaurant, shop, office, and commercial build-outs on San Anselmo Avenue — the town’s downtown street — when the drawing says steel studs. If the plan names metal, that is the bid. Commercial framing →
Sir Francis Drake and Red Hill interiors
Shop and office partitions on Sir Francis Drake Boulevard, Red Hill Avenue, and Center Boulevard around the Hub. Occupied buildings change the layout — not the stud spec.
Tunstead, Butterfield, and 94960 interiors
House and small-shop partitions on Tunstead Avenue, Butterfield Road, and other Town of San Anselmo streets. A Sleepy Hollow lot that only uses a 94960 mailing ZIP may be unincorporated — text the street.
House remodel and ADU partitions
New interior steel walls inside an existing San Anselmo house when the finish needs a straighter plane than bowed lumber. Wood structure stays wood unless the plan says otherwise. Metal vs wood →
Soffits, bulkheads, and chases
Dropped ceilings, kitchen hood wraps, and framed openings so boxes, ducts, and lights have a home before drywall.
Fire-rated and heavier-gauge walls
Listed assemblies, Type X board later, and heavier studs when the plan or the engineer calls for them. The rating is the whole wall — not the stud alone.
Frame and hang together
One crew frames the metal, hangs the board, and can finish it. Split bids leave missing backing and wavy walls. Services →
Which Stud Belongs on a San Anselmo Job
| Stud | Use it when | Skip it when |
|---|---|---|
| Light-gauge metal (what we frame) | San Anselmo Avenue TI, Red Hill shop, rated walls, or a finish that needs a flat plane for Level 4 / Level 5 | You need beams, columns, or structure that hold the building up — that is a different contractor |
| 25-ga interior studs | Short, non-load-bearing partitions with a normal finish | Tall walls, high-abuse corridors, or a spec that names 20-ga or heavier |
| 20-ga / heavier track and studs | Taller commercial walls, restaurant TIs, or engineer notes | A simple closet that never needed the extra gauge |
| Wood studs | Most San Anselmo house walls with no commercial spec | The plan already says steel, or the finish will show every bow |
| Furring / hat channel on masonry | Brick, stone, or masonry walls that need a cavity for boxes before drywall | Glue-only board on a finished living space |
Compare studs: Metal vs wood → · Cost: Is steel expensive? → · Why it stays flat: Steel benefits →
San Anselmo Streets, ZIP, and Permits
San Anselmo is an incorporated town in Marin County — Ross Valley. This page uses street ZIP 94960. 94979 is a San Anselmo PO Box. Area codes are 415 and 628. Nearby Fairfax uses 94930. San Rafael uses 94901 and 94903. Ross uses 94957. Text the street so the bid matches Town of San Anselmo Building Department — not Town of Fairfax Building at 142 Bolinas Road, not City of San Rafael Building at 1400 Fifth Avenue, not Town of Ross Building at 31 Sir Francis Drake Boulevard, and not Marin County Building at 3501 Civic Center Drive for an unincorporated parcel.
Permits for Town of San Anselmo addresses run through Town of San Anselmo Building Department, 525 San Anselmo Avenue, Second Floor, San Anselmo, CA 94960. Call (415) 258-4616 or (415) 258-4646. Email: permits@sananselmo.gov. Town site is townofsananselmo.org. Sleepy Hollow and other unincorporated lots that only use a 94960 mailing ZIP run through Marin County Building — a different office.
Fairfax sits west. San Rafael sits east. Ross sits south. Sir Francis Drake Boulevard, Red Hill Avenue, and Center Boulevard meet at the Hub. San Anselmo Avenue is downtown. Text the street so the bid matches Town of San Anselmo for a town address — not a Fairfax 94930 permit, and not a San Rafael 94901 permit.
Commercial work sits on San Anselmo Avenue, Sir Francis Drake Boulevard, Red Hill Avenue, Center Boulevard, and Tunstead Avenue. Occupied houses and open shops change the layout — not the stud spec.
The usual mismatch is treating a San Anselmo Avenue shop wall like a bedroom 2×4 — or hanging a Level 5 commercial finish on house framing that only needed wood hang-only. Interior metal studs do not hold the building up. Occupied houses and open shops need a clean layout, backing for cabinets and TVs, and a stud plane the finish can live with. Matching the spec still beats guessing the gauge. Send the plan sheet or a wide shot of the room. That photo decides wood hang-only vs new metal studs faster than a ZIP code.
How a San Anselmo Metal-Stud Job Runs
1. Photos + place
Text (925) 791-9099 San Anselmo, the street, and the plans or a photo of the wall.
2. Name the wall
Partition, TI layout, soffit, rated assembly, house remodel, or frame-and-hang. We will say if the existing framing can take the finish.
3. We frame it
Protect the space. Track, studs, backing, hang if scoped. Ready for inspection and board. 12-month warranty on our work.
San Anselmo, CA
This page is steel and metal stud framing in San Anselmo — ZIP 94960, Town of San Anselmo, Marin County — from our Fairfield shop. Town Building Department is at 525 San Anselmo Avenue. Need the board hung and finished on the same job? Services → · Commercial framing: Commercial → · Contact: Contact →
Office: 2380 Palmer Circle, Fairfield, CA · CSLB #265709 · Check the number on cslb.ca.gov.
Not on This Page
No Town of Fairfax permit at 142 Bolinas Road for a San Anselmo lot. No City of San Rafael permit at 1400 Fifth Avenue. No Town of Ross permit at 31 Sir Francis Drake Boulevard. No Marin County Building permit at 3501 Civic Center Drive for a town lot. No storefront on San Anselmo Avenue. No structural steel building. No promise that metal studs hold the building up. We frame interior light-gauge walls and hang drywall on wood or steel. A closet does not need a shaft-wall spec. Fairfax, San Rafael, Ross, Sleepy Hollow, and other addresses that only share a nearby ZIP are different places. This page is San Anselmo, CA, ZIP 94960, Town of San Anselmo — text the street so the permit office matches the address.
San Anselmo Metal Stud FAQs
Do you do steel / metal stud framing in San Anselmo?
Yes. Interior light-gauge metal stud framing in San Anselmo, CA from our Fairfield shop — partitions, San Anselmo Avenue TIs, Sir Francis Drake and Red Hill interiors, house walls, soffits, heavier-gauge spec walls, and frame-and-hang.
Is San Anselmo a city?
San Anselmo is an incorporated town in Marin County. The Town of San Anselmo incorporated on April 9, 1907. Building permits inside town limits run through Town of San Anselmo Building Department at 525 San Anselmo Avenue — not Fairfax, not San Rafael, not Ross, and not Marin County Building.
Is this structural steel?
No. We frame interior light-gauge studs, track, headers, and soffits. Beams, columns, and structure that hold the building up are a different contractor.
Do San Anselmo houses use metal studs or wood?
Most house walls here are still wood. Metal wins on San Anselmo Avenue TIs, rated walls, and remodels that need a straighter plane for a smooth finish. If the drawing names the stud, that wins.
Can you frame a shop on San Anselmo Avenue?
Yes. Occupied retail, restaurant, office, and commercial tenant improvements on San Anselmo Avenue, Sir Francis Drake Boulevard, and Red Hill Avenue are a usual request — new partitions, soffits, and backing, then hang if the scope includes board.
Do you work occupied San Anselmo buildings?
Yes. Floors are protected and the layout is planned around an occupied house or an open shop. Downtown storefronts need a clean layout — not a guessed gauge.
Is 94930 San Anselmo?
No. 94960 is the San Anselmo street ZIP. 94979 is a San Anselmo PO Box. 94930 is Fairfax. Nearby San Rafael uses 94901. Ross uses 94957. Text the street so the bid matches Town of San Anselmo Building Department.
Do you work San Anselmo Avenue, Sir Francis Drake, and Red Hill?
Yes. San Anselmo Avenue, Sir Francis Drake Boulevard, Red Hill Avenue, Center Boulevard, Tunstead Avenue, and other Town of San Anselmo 94960 addresses are on this framing page. Text the street with the photos.
What ZIP does this San Anselmo page cover?
This page covers San Anselmo 94960 street addresses inside the Town of San Anselmo. 94960 is the ZIP on this URL. Text the street with the photos so the bid matches Town Building Department — not Fairfax 94930, not San Rafael 94901, and not Marin County Building for a county parcel.
Who issues the permit in San Anselmo?
Town of San Anselmo Building Department, 525 San Anselmo Avenue, Second Floor, San Anselmo, CA 94960. Call (415) 258-4616. Town of Fairfax Building is a different office. City of San Rafael Building is a different office. Town of Ross Building is a different office. Marin County Building and Safety is a different office for unincorporated parcels.
How much does metal stud framing cost in San Anselmo?
It follows the gauge, wall height, how cut-up the layout is, fire rating, access, and whether we only frame or also hang and finish. Photos or plans first. Written scope — no hidden fees.
Are you licensed in California?
Yes. CSLB #265709. Look it up before you book us or anyone else. Work at a Town of San Anselmo 94960 address uses Town of San Anselmo Building Department — not a Fairfax, San Rafael, or Ross permit, and not Marin County Building unless the lot is unincorporated.
Need San Anselmo Walls Framed Straight — Then Hung?
Call the family-owned crew that has been framing interiors and hanging board since 1970.
Call / Text (925) 791-9099
