Loomis, CA 95650 • Incorporated 1984 • Town of Loomis • Placer County • Family-Owned Since 1970 • CSLB #265709
Steel / Metal Stud Framing in Loomis, CA
Light-gauge steel and metal stud framing in Loomis — interior partitions, tenant-improvement walls, soffits, and fire-rated assemblies. We frame the wall so the drywall stays flat: Taylor Road and Horseshoe Bar shops, King Road interiors, and large-lot house remodels in 95650.
Loomis Framing From the Fairfield Shop
Ron Hogan Drywall has been family-owned since 1970. We are based in Fairfield — a Sacramento Valley run, not a Taylor Road storefront. Loomis is an incorporated town in Placer County — not Rocklin, not Granite Bay, and not Penryn. It has its own Building Department at 3665 Taylor Road. Street ZIP 95650 is Loomis. That ZIP also covers parts of Granite Bay, Rocklin, Lincoln, and Penryn outside town limits. 95677 and 95765 are Rocklin. 95746 is Granite Bay. 95663 is Penryn. This page is steel / metal stud framing at Town of Loomis addresses — Taylor Road, Horseshoe Bar Road, King Road, and Sierra College Boulevard. The street decides the bid.
Text “Loomis” with the plans or a photo of the room. If the scope is interior metal studs — or frame-and-hang on the same trip — we schedule it.
Metal Stud Work We Do in Loomis
Interior partition walls
Track, studs, and bracing for new rooms, office layouts, and non-load-bearing walls at Town of Loomis addresses. This is the skeleton the board hangs on.
Taylor Road and Town Center TIs
Restaurant, shop, office, and commercial build-outs on Taylor Road, Horseshoe Bar Road, and around the High Hand / Blue Goose block when the drawing says steel studs. If the plan names metal, that is the bid. Commercial framing →
King Road and Sierra College interiors
Retail, office, and occupied-building partitions on King Road, Sierra College Boulevard, Brace Road, and Webb Street. Occupied buildings change the layout — not the stud spec.
Large-lot house remodel partitions
New interior steel walls inside an existing Loomis house when the finish needs a straighter plane than bowed lumber. Wood structure stays wood unless the plan says otherwise. Rural streets change the layout — not the stud spec. Metal vs wood →
Soffits, bulkheads, and chases
Dropped ceilings, kitchen hood wraps, and framed openings so boxes, ducts, and lights have a home before drywall.
Fire-rated and heavier-gauge walls
Listed assemblies, Type X board later, and heavier studs when the plan or the engineer calls for them. The rating is the whole wall — not the stud alone.
Frame and hang together
One crew frames the metal, hangs the board, and can finish it. Split bids leave missing backing and wavy walls. Services →
Which Stud Belongs on a Loomis Job
| Stud | Use it when | Skip it when |
|---|---|---|
| Light-gauge metal (what we frame) | Taylor Road TI, Horseshoe Bar shop, rated walls, or a finish that needs a flat plane for Level 4 / Level 5 | You need beams, columns, or structure that hold the building up — that is a different contractor |
| 25-ga interior studs | Short, non-load-bearing partitions with a normal finish | Tall walls, high-abuse corridors, or a spec that names 20-ga or heavier |
| 20-ga / heavier track and studs | Taller commercial walls, restaurant TIs, or engineer notes | A simple closet that never needed the extra gauge |
| Wood studs | Most Loomis house walls with no commercial spec | The plan already says steel, or the finish will show every bow |
| Furring / hat channel on masonry | Concrete, brick, or masonry walls that need a cavity for boxes before drywall | Glue-only board on a finished living space |
Compare studs: Metal vs wood → · Cost: Is steel expensive? → · Why it stays flat: Steel benefits →
Loomis Streets, ZIP, and Permits
Loomis is an incorporated town in Placer County — on Interstate 80 between Rocklin and Penryn. The Town of Loomis incorporated on December 17, 1984 so it would not be annexed by Rocklin. This page uses street ZIP 95650. That ZIP also covers parts of Granite Bay, Rocklin, Lincoln, and Penryn outside town limits. 95677 and 95765 are Rocklin. 95746 is Granite Bay. 95663 is Penryn. 95658 is Newcastle. Area codes are 916 and 279. Text the street so the bid matches Town of Loomis Building Department — not City of Rocklin Building at 3970 Rocklin Road, not City of Roseville Building at 311 Vernon Street, and not Placer County Building at 3091 County Center Drive in Auburn for a Penryn or Granite Bay county lot.
Permits for Town of Loomis addresses run through Town of Loomis Building Department, 3665 Taylor Road, Loomis, CA 95650. Call (916) 652-1840. Email: building@loomis.ca.gov. Town site is loomis.ca.gov. A 95650 mailing ZIP on Granite Bay, Penryn, or an unincorporated lot uses a different office. Greater Loomis Basin is not the same as town limits.
Rocklin sits west. Granite Bay sits south. Penryn sits north. Newcastle sits northeast. I-80 cuts through town. Taylor Road is downtown — historic Highway 40, next to the Union Pacific tracks and the High Hand / Blue Goose sheds. Horseshoe Bar Road is the I-80 interchange and town-center pair. King Road and Sierra College Boulevard carry shops and houses. Text the street so the bid matches Town of Loomis for a town address — not a Rocklin 95677 permit, and not a Granite Bay 95746 county path.
Commercial work sits on Taylor Road, Horseshoe Bar Road, King Road, Sierra College Boulevard, Brace Road, and Webb Street. Occupied houses and open shops change the layout — not the stud spec.
The usual mismatch is treating a Taylor Road shop wall like a bedroom 2×4 — or hanging a Level 5 commercial finish on house framing that only needed wood hang-only. Interior metal studs do not hold the building up. Occupied houses and open shops need a clean layout, backing for cabinets and TVs, and a stud plane the finish can live with. Matching the spec still beats guessing the gauge. Send the plan sheet or a wide shot of the room. That photo decides wood hang-only vs new metal studs faster than a ZIP code.
How a Loomis Metal-Stud Job Runs
1. Photos + place
Text (925) 791-9099 Loomis, the street, and the plans or a photo of the wall.
2. Name the wall
Partition, TI layout, soffit, rated assembly, house remodel, or frame-and-hang. We will say if the existing framing can take the finish.
3. We frame it
Protect the space. Track, studs, backing, hang if scoped. Ready for inspection and board. 12-month warranty on our work.
Loomis, CA
This page is steel and metal stud framing in Loomis — Town of Loomis lots in 95650 — from our Fairfield shop. Town Building Department is at 3665 Taylor Road. Need the board hung and finished on the same job? Services → · Commercial framing: Commercial → · Contact: Contact →
Office: 2380 Palmer Circle, Fairfield, CA · CSLB #265709 · Check the number on cslb.ca.gov.
Not on This Page
No City of Rocklin permit at 3970 Rocklin Road. No City of Roseville permit at 311 Vernon Street. No Placer County Building permit at 3091 County Center Drive, Auburn, for a Town of Loomis lot. No claim that every 95650 address is inside town limits — Granite Bay, Penryn, and some Rocklin and Lincoln lots share that ZIP. No Granite Bay 95746 page. No Penryn 95663 page. No storefront on Taylor Road. No structural steel building. No promise that metal studs hold the building up. We frame interior light-gauge walls and hang drywall on wood or steel. A closet does not need a shaft-wall spec. Rocklin, Granite Bay, Penryn, and other addresses that only share I-80 or 95650 are different places. This page is Loomis, CA, Town of Loomis — text the street so the permit office matches the address.
Loomis Metal Stud FAQs
Do you do steel / metal stud framing in Loomis?
Yes. Interior light-gauge metal stud framing in Loomis, CA from our Fairfield shop — partitions, Taylor Road and Horseshoe Bar TIs, King Road and Sierra College interiors, large-lot house walls, soffits, heavier-gauge spec walls, and frame-and-hang.
Is Loomis a city?
Loomis is an incorporated town. The Town of Loomis incorporated on December 17, 1984. Building permits inside town limits run through Town of Loomis Building Department at 3665 Taylor Road — not Rocklin, not Granite Bay, not Penryn, and not Placer County Building in Auburn.
Is Loomis the same as Rocklin?
No. Loomis incorporated in 1984 so it would not be annexed by Rocklin. Rocklin uses ZIPs 95677 and 95765 and City of Rocklin Building at 3970 Rocklin Road. A Sierra College Boulevard address can sit one town over. Text the street.
Does 95650 always mean Town of Loomis?
No. 95650 is the Loomis ZIP, but it also covers parts of Granite Bay, Rocklin, Lincoln, and Penryn. Text the street so the bid matches Town of Loomis Building — not Rocklin city limits, not Granite Bay, and not Placer County Building for a county lot.
Is this structural steel?
No. We frame interior light-gauge studs, track, headers, and soffits. Beams, columns, and structure that hold the building up are a different contractor.
Do Loomis houses use metal studs or wood?
Most house walls here are still wood. Metal wins on Taylor Road and Horseshoe Bar TIs, rated walls, and remodels that need a straighter plane for a smooth finish. If the drawing names the stud, that wins.
Can you frame a shop on Taylor Road or Horseshoe Bar?
Yes. Occupied retail, restaurant, office, and commercial tenant improvements on Taylor Road, Horseshoe Bar Road, King Road, and Sierra College Boulevard are a usual request — new partitions, soffits, and backing, then hang if the scope includes board.
Do you work occupied Loomis buildings?
Yes. Floors are protected and the layout is planned around an occupied house or an open shop. I-80 and Taylor Road traffic change the schedule — not the stud spec.
What ZIP does this Loomis page cover?
This page covers Town of Loomis street addresses in 95650. That ZIP also serves parts of Granite Bay, Rocklin, Lincoln, and Penryn. Text the street with the photos so the bid matches Town of Loomis Building Department.
Do you work Taylor Road, Horseshoe Bar, King Road, and Sierra College?
Yes. Taylor Road, Horseshoe Bar Road, King Road, Sierra College Boulevard, Brace Road, Webb Street, and other Town of Loomis addresses are on this framing page. Text the street with the photos.
Who issues the permit in Loomis?
Town of Loomis Building Department, 3665 Taylor Road, Loomis, CA 95650. Call (916) 652-1840. Email building@loomis.ca.gov. City of Rocklin Building is a different office. City of Roseville Building is a different office. Placer County Building in Auburn is a different office for Penryn, Granite Bay county lots, and other unincorporated parcels.
How much does metal stud framing cost in Loomis?
It follows the gauge, wall height, how cut-up the layout is, fire rating, access, and whether we only frame or also hang and finish. Photos or plans first. Written scope — no hidden fees.
Are you licensed in California?
Yes. CSLB #265709. Look it up before you book us or anyone else. Work at a Town of Loomis address uses Town of Loomis Building Department — not Rocklin, not Roseville, and not Placer County Building unless the lot is unincorporated.
Need Loomis Walls Framed Straight — Then Hung?
Call the family-owned crew that has been framing interiors and hanging board since 1970.
Call / Text (925) 791-9099
